|
|
K93500
Pin on Disc Tester
The Pin-On-Disc
Tester is used to test the friction and wear characteristics of dry or
lubricated sliding contact of a wide variety of materials including metals,
polymers, composites, ceramics, lubricants, cutting fluids, abrasive
slurries, coatings, and heat-treated samples. The test is performed by
rotating a counter-face test disc against a stationary test specimen pin.
Wear, friction force, and interface temperature can be monitored using
TriboDATA, the supplied Windows-based Data Acquisition Software. The normal
load, rotational speed, and wear track diameter can be adjusted in accordance
with ASTM G99 test standard.
Specifications
Power: 500 VA
Sliding Speed Range: 0.26 m/sec to 10 m/sec
Disc Rotation Speed Range: 100 - 2000 rpm
Normal Load: 200 N Maximum
Friction Force: 0 - 200 N
Wear Measurement Range: up to 4mm
Pin Size: 3mm to 12mm diagonal /diameter
Disc Size: 160mm diameter x 8mm thick
Mean Wear Track Diameter: 10mm to 140mm
Pin on Disc Tester with Environmental Control Chamber
Temperature 60°C maximum
Pin on Disc Tester with Lubricant Recirculation System
Discharge Rate 0 - 1 L/min
Viscosity Range: 90 SAE maximum
Capacity: 3L of lubricant
Electrical Requirements
Koehler will configure your tribo-tester to operate within the
electrical capacity of your facility. Please contact Koehler Customer
Service.
Included Accessories
Electronic Controller
Connecting Cables
Fuses (2), spare
Data Acquisition Card
TriboDATA Data Acquisition Software
Set of Weights
Set of Hand Tools
Set of Pins
Operating and Maintenance Manual
Calibration and Test Reports
|
